Euro-4 Advanced System for Engines with up to 8 Cylinders
4x VR input
Pris:
9.900 kr
Lasse Kofoed
50504525
lassekofoed@gmail.com
Beskrivelse:
Management system for engines having up to 8 cylinders Drive-by-wire throttle control Variable camshaft timing (multi-cam control) Paddle shift with closed loop control 2 x CAN 2.0 ports for data import and export Built-in high speed data logger Automatic closed loop fuel mapping Traction control Knock control Software for direct injection engines (requires external DI driver module - see EFR14)
System overview
- PowerPC microprocessor
- 8 cylinder fully sequential fuel injection
- Dual-stage fuel injection for stand off injectors
- Ignition output handles both logic and inductive coils.
- Drive by wire throttle PID control
- On-board data logger with high speed sampling rates (200hz)
- Automatic fuel mapping
- Closed-loop lambda control
- Closed-loop boost control
- Closed-loop traction control
- Closed-loop paddle shift control
- Closed-loop variable camshaft control (VCT, VVT, VANOS etc.)
- Closed-loop direct injection fuel pump Bosch and Hitachi (external driver required)
- Closed-loop water pump control
- Closed-loop pit lane speed control
- Closed-loop idle control (ETB, stepper motor, ISC valve and ignition)
- 2 driver selectable calibrations
Inputs
- 20 analog inputs (0-5v)
- 8 user defined CAN inputs
- 4 trigger inputs (Hall/VR) for crank and cam sensors
- 4 wheel speed inputs (Hall)
- 3 spare digital inputs
- 2 knock sensors
- Built-in wide band lambda controller plus inputs for 3 external lambda controllers
- Built-in barometric pressure sensor
Outputs
- 8 fuel injector drivers
- 4 inductive and 4 logic ignition drivers
- 8 multipurpose PWM and relay outputs
- 1 wide band lambda sensor heater
- 1 electronic throttle body (full H-bridge)
- 1 stepper motor driver (full 4-phase)
- 4 independent 5V sensor power supply
Communications
- 2 CAN 2.0B interfaces
- Multiple pre-programmed and user defined CAN export and import
- FIA RX datalogger
- Bosch ABS data import
- General data import and export
- VW Dash protocol (500Kbit)
- 16 CAN identifiers available for export
- 2 CAN identifiers available for import
Special features
- 4 lambda sensors for individual closed loop PID cylinder trim
- Special engine trigger patterns including several for motorcycle engines
- Control strategy for paddle shift and air compressor
- Control strategy for sequential closed loop gear change
- Traction control with target slip maps and PID control
- Pit lane, launch and external adjustable manual limiter
- Programmable firing order
- Knock control
- Comprehensive CAN features
- Special version available with fully encrypted software
- Launch control (with advanced rpm vs time curve)
General
- Dimensions (very small and light)
- Weight 365g (13 oz.)
- 165 x 95 x 21mm (6 1/2" x 4 3/4" x 7/8")
- All aluminum and high-end vibration stable SMD PCB
- 2 automotive Molex connectors with high pin density (96 in total)
Conditions for usage
- Temperature range -40 to 125 Celsius (-40 to 257 Fahrenheit)
- Power supply 7-16v
- Splash-proof
|